When using and installing the non-leakage magnetic pump, you must pay attention to these points!

The over-current part of the non-leakage magnetic pump is made of all stainless steel, which has good corrosion resistance to organic acid, organic compound, alkali, neutral solution and many kinds of gases. The running-in of double spiral groove carbon graphite bearing and cemented carbide shaft sleeve has strong wear resistance and ensures the life of the product. it is an ideal pump for conveying corrosive media without leakage. The ideal pump type for conveying corrosive media without leakage, and the optimized product designed jointly by the whole country, can directly replace the stainless steel chemical pump.

Key points of installation and use of non-leakage magnetic pump:

1. The stainless steel magnetic pump should be installed horizontally, not erect, and the plastic pump body shall not bear the weight of the pipeline. for the special requirements for vertical installation, the motor must face up.

2. When the suction level is higher than the pump axis line, open the suction pipe valve before starting. If the suction level is lower than the pump axis line, the pipe should be equipped with bottom valve.

3. The stainless steel magnetic pump should be checked before use, the rotation of the motor blade should be flexible, no jam, no abnormal sound, and the fasteners should be fastened.

4. Check whether the rotation direction of the motor is in line with the steering mark of the magnetic pump.

5. After the motor starts, slowly open the discharge valve, wait for the pump to enter the normal working state, and then adjust the discharge valve to the desired opening.

6. Before stopping work, close the discharge valve, and then close the suction valve.